Short instruction into operation
3D-milling arm
operating unit
integrated
arm supports
height-
adjustable.
Milling table
activate mains switch
(4)
jointed arm
- Fastening and loosening is done with the foot switch
(6)
- adjust the additional, third joint with thumb drive
(15)
- When the milling machine is not in use please place the milling arm
into ’parking postion’ (pict. 2; page 9)
vertical saddle
- adjust the vertical saddle at any position using knurled nut
(8)
- use lever
(11)
to draw spindle down
fine adjustment through micrometer spindle
(9)
milling spindle
- tension lever
(31)
showing to the left when chuck is closed
- motor on/off with switch “Motor - EIN/AUS”
(18)
resp. foot switch
(7)
- speed adjustment variable with speed selector
(19)
- digital speed indicator
(22)
- magnet on / off use switch “Magnet - EIN/AUS”
(20)
- changing rotation of milling spindle by using switch “Motor - R/L”
(21)
- adjusment possible at any position through notches
- height adjustment through thumb drive
(23)
- loosen clamping lever
(26)
; for height adjustment use handwheel
(25)
- position of clamping lever can be adjusted at any position desired by
pulling and turning.
- Height stop
(28)
to mark and to find again the starting point of the
milling table
- gap
(29)
at magnet plate to remove easily cuttings etc.
Important !
Detailed description see point 7 “Operation”
5. Operation
7