Maintenance and care
Possible faults
10. Maintenance and care
CAUTION!: Do not clean milling machine and milling spindle with
compressed air !
The chuck should be cleaned and re-greased once in a while, depending on how dirty it is
see “Replacement of chuck” (point 9; page 13)
-
As the S3 milling spindle has no commutators, carbon brushes or ventilation parts,
no further maintenance is required.
- The wood of the arm supports is natural and superficially waxed.
- All guideways are maintenance free.
For cleaning please use only a brush !
Before cleaning please switch the milling machine off and withdraw mains plug !
!
11. Possible faults
- Should the milling spindle be overloaded, respectively, jammed, for safety
reasons the unit will switch off.
- turn speed selection
(19)
back to “0-postion”; select the desired speed and the
machine is ready for use again.
- alternatively switch mains switch
(4) off
and
on
again.
If after that the machine is not working please check the fuses and replace them if necessary.
The fuses
(5)
(230V
→
2x T2AH250V art.no.:3106) (100-115V 2x T4AH
are to
be found beside the socket for the mains cable
(3)
(see page 6).
Should it not be possible to abolish the faults please contact SCHICK directly
art.no.: 7306)
14