4
3
5
Installation and setting up
Setting up
Put the connection plugs of foot-switch (magnet-coupling)
(6a)
and foot-switch (motor)
(7a)
on to the sockets situated on
the right side of the milling machine (see picture). Press both plugs
carefully into the sockets.
Please note at both plugs the security against torsion !
The foot-switch (magnet-coupling) is equipped with a thread
connection, the foot-switch (motor) with a bayonet connection.
So both plugs can be connected with the sockets tightly
Dimmer is used for the stepless adjustement of light intensity.
Connect the milling machine with the mains supply by placing
the mains cable at first into the socket
(3)
situated on the left
side of the milling machine and then into a safe wall socket
with earth connection.
Please check that all plug connections are readily fixed !
Foot-switch
Mains cable
4. Installation
- Check the package for visible damages
- When unpacking handle all parts of consignment with care.
- Remove carefully the upper part of the inside package (withdraw
slowly (pict.. 1)).
Please look that parts of the milling machine do not become
wedged with the package.
- Remove cartons containing accessories (pict. 2)
IMPORTANT: When unpacking the accessories please note
the sign “OBEN” (pict. 3) !
- Look for the space where to place the milling machine
- Using your left hand hold the milling machine at the column
Do not hold at the milling arm !
- Withdraw the machine a little bit and then hold it with your rigth
hand at the basic plate to take the milling machine out.
Please look for the milling arm being fixed.
- Check all parts for visible damages. Place all parts of inner
package back into the outer carton.
Store the complete package for an eventual return to manufacturer.
If you should intend to destruct the package, please be so kind
to return the complete package to SCHICK.
Pict. 1
pict. 2
Pict. 3
7a
2
1
6a
7a
2
1
6a
dimmer
6