Operation
When replacing the milling spindle pull down until stop.
Please pay attention that the thread pin placed in the spindle
holder clicks into the notch at the milling spindle.
The lever
(31)
(pict. 2) at the milling spindle has to show into left
direction. Tighten knurled nut
(13).
Function of milling spindle see “ operating unit “ (point 7.2)
Measuring spindle
The measuring spindle
(17)
is supplied as accessory
and can be
placed into the spindle holder in the same way as the milling spindle.
There is no stop position what allows to place the measuring spindle
in each desired height position.
If the measuring spindle is not in use it can be placed into the holding
hole
(12)
in the back part of the milling arm.
7.2 Operating unit
The operating unit is flexible connected to the milling machine.
This flexible connection allows positioning to the optimum
ergonimic, individual working position.
Milling spindle ON / OFF
The milling motor is switched on and off either by using the operating
unit directly (switch “Motor - EIN/AUS”
(18)
) or by using the supplied
foot-switch (Motor)
(7).
If motor is switched on control light is shining.
Speed of milling spindle
The speed of the milling spindle is variable adjusted from 1.000 -
50.000 min¯¹ by turning speed selector knob
(19)
.
The choosen speed is clearly visible at the integrated digital
display
(22).
If there is a point visible left from the shown speed the
motor is not switched on (to select the speed). As soon as the spindle
is rotating the point disappears.
Magnet milling table
To lock resp. to loosen of f.e. model table or coordiante table an
electric magnet is used. Press the switch “Magnet -EIN/AUS”
(20)
;
the control light in the switch is shining.
To inactivate the magnet press the switch again.
22
20
18
19
21
17
12
10