2
B1051302 Rev. B
CDR Wireless Installation
1.3. New Wireless System Installation Overview
STEP 1.
Verify that USB Interface is NOT
connected to host computer.
Connect USB Interface to Receiver
and place Sensor in Cradle.
STEP 2.
Install CDR Wireless software, which
also pre-installs USB driver.
STEP 4.
Click Start at Wireless Utility screen and
run RF environment test in scan mode.
Set RF channel for Sensor and Receiver.
STEP 5.
Remove Sensor for Cradle, attach
battery pack, and turn Sensor on.
Start Sensor monitor to check battery life,
signal strength, and RF noise.
STEP 7.
Start CDR DICOM software and install
Sensor calibration file using diskette
supplied.
Section
2.1
Section
2.2
Section
2.3
Section
2.4
Section
2.5
STEP 6
Position Sensor, USB Interface, and
Antenna / Receiver for optimal placement
(highest signal, lowest noise).
STEP 3.
When prompted, connect USB
Interface to host computer. Follow Add
New Hardware Wizard to complete CDR
Wireless software installation.
