8
B1051302 Rev. B
CDR Wireless Installation
5. Click Read Info for the USB Interface.
•
Click Upgrade CPLD.
•
When upgrade is complete, verify that revision numbers are black not red.
6. Click Read Info for the Sensor.
•
Click Upgrade CPLD.
•
When upgrade is complete, verify that revision numbers are black not red.
7. Click Read Info for the Receiver.
•
Click Upgrade Firmware.
8. When upgrade is complete, verify that revision numbers are black not red.
3.4. Checking for RF Noise
1. Click RF environment.
2. Click
Live.
3. Click
Scan.
4. After approximately 2 – 3 minutes, click Stop Logging.
5. Review the results and write down the recommended RF channel(s).
6. Close the RF environment window.
3.5. Performing Final Check
1. Verify that the currently set RF channel is recommended. If not, click the Sensor
arrow to select a recommended channel and click the Match Channels checkbox to
automatically set the Receiver. Both the Sensor and Receiver must be set to the same
RF channel to communicate with each other.
2. Click OK to close the Wireless Utility.
