CDR Wireless Installation
B1051302 Rev. B
9
4. Wireless Sensor Setup
Before using the Wireless Sensor, it must be configured to transmit on one of three RF
channels, as follows:
4.1. Preparing the Sensor
To configure the Wireless Sensor, perform the following steps. You need to perform this
procedure before the Sensor is used the very first time and when you want to change the
Sensor’s channel to avoid interference.
Please Note: To perform the next step, follow the directions in
to remove the
battery package properly from the Sensor.
1. Remove the battery pack from the Sensor by sliding and lifting it away from Sensor.
2. Disconnect the USB cable from the USB Interface.
Please Note: To perform the next step, follow the directions in
to place the Sensor
properly in the cradle area.
3. Place the Sensor with contacts side down into Sensor cradle located under the lid of
the USB Interface.
4. Reconnect the USB cable to the USB Interface.
