XII. Troubleshooting
Problem
Possible Cause
Help
Device
does
not start or lacks
power.
Piston jammed (rusted) in the
housing due to a lack of oil.
Press the piston back with a strik-
ing bolt through the tool receiver.
Introduce a little oil into the
connection hose and into the tool
receiver.
Run the device briefly without a
tool.
Repeat this process a few times.
Dirt has penetrated via the air
hose.
Repair must be carried out by a
specialist workshop.
Too much lubricating oil used or
water in the striking mechanism.
Run the device briefly without a
tool.
Pressing force too high.
Grease tool receiver and reduce
pressing force.
Output power of the air source
too low.
Use an air source with a higher
output power.
Tool no longer
latches into the
tool receiver or
does not lock into
place.
Tool or tool receiver worn out.
(Most often caused by excessive
pressure or no-load strokes).
Repair must be carried out by a
specialist workshop.
Tool cannot be in-
serted or removed.
Dirt in the sliding sleeve pre-
vents unlocking.
Repair/cleaning must be carried
out by a specialist workshop.
Device operates
continuously
without the trigger
lever being actu-
ated.
Valve defective.
Repair must be carried out by a
specialist workshop.
AUS
Troubleshooting
AERO
2
SPADE
22
AFTER SALES SUPPORT
1300 130 570
MODEL: AERO
2
SPADE PRODUCT CODE: 59540 04/2018
1300 855 831
