resistance of the tool guide so that the impact drives forwards and the device
does not jump up but rather works the material instead.
5. A limited degree of levering is possible. Too powerful levering can result in the
shaft (3) or the tool (7; 8; 9; 10 or 11) breaking.
m
Risk of injury! Danger of
stumbling if the shaft or tool breaks, due to an unexpected weight shift.
Do not lever too severely.
6. If you release the trigger lever (4), the compressed air feed is interrupted. The
device stops with a brief run-on time.
m
Risk of injury! Danger of extremely
serious or even fatal injuries or damage to the device or tool if the trigger
lever is permanently locked. Never lock the trigger lever with cable ties,
adhesive tape or by other means.
Check that the tool receiver (1) has been furnished with an oil film, after 2 hours of
operation at the latest. If this is not the case, introduce a few drops of special oil into
the connection hose. We recommend operating the device in conjunction with a
maintenance unit with mist oiler as a matter of principle.
It is useful to grease the hex. tool receiver with large pressing forces.
Excessive oil damps the impact performance. Drops are forming on the trigger lever
or on the tool receiver. In this case, reduce the oil quantity on the oiler and clean
the device if necessary. Inadequate oil will result in damage to the device and tool.
Check oil feed and top up oil or adjust oiler if required.
End of work
Interrupt the compressed air supply from the compressed air hose to the device.
With breaks in work:
Place the device safely to one side.
If there are sharp or pointed tools in the device, cover these up.
At the end of work:
Interrupt the compressed air supply.
Remove the tool from the device.
Check that the tool receiver has been furnished with an oil film.
If this is not the case, introduce a few drops of special oil into the connection hose
and operate the device without tool for ca. 15 seconds.
Clean the device, the tools, the hose and any other accessories with a dry or oily,
clean cloth.
AFTER SALES SUPPORT
19
1300 855 831
MODEL: AERO
2
SPADE PRODUCT CODE: 59540 04/2018
AUS
AERO
2
SPADE
Operation
