english 13
Fig. 11
The locking lever is pre-set to zero clearance by default.
By means of the adjustment screw, the locking lever may
be readjusted, if required.
Angular stop, Fig. 12, 13
The angular stop (A) may be inserted in the height-
adjustable traverse table or the lateral table for angle
grinding.
The angular stop can be locked by using the rotary knob
(B).
Tube with mechanical stop unit, Fig.14
The stop tube (1) must not topple outwards during surface
grinding.
If required, retighten both safety lock nuts (2) at the
joint.
Height adjustment of the traverse table, Fig. 15
After unfastening both clamping handles (C), the grind-
ing belt can be used optimally with the height-adjustable
traverse table during the grinding process.
After having performed the adjustment, fasten the clamp-
ing handles again.
Extraction for the lateral table, Fig. 16
For work on the lateral table, the extraction nozzle (D) is
removed from the traverse grinding and attached to the
traverse table by means of a clamping screw (E).
Maintenance
Prior to each maintenance and cleaning, the motor must
be turned off and the mains plug disconnected.
All protective and safety equipments must be mounted
again immediately after repair and maintenance work
have been completed.
Grinding belt replacement, Fig. 17
1 Fold out the sanding stop plate.
2 Open the protective screen.
3 Unfasten the wing nut on the extraction nozzle and pull
the latter one backwards.
4 Release the old grinding belt and remove it.
5 While placing the new grinding belt, observe the ar-
rows for running direction on the inside of the grinding
belt.
6 Tighten the grinding belt.
7 Attach the extraction nozzle to the grinding belt again
and fasten the wing nut.
8 Adjust the belt run while the machine is running.
Belt replacement, Fig. 18
1 Remove the belt protection (1)
2 Unscrew the bearing flap (2)
3 Unfasten the 4 motor attachment screws (3)
4 Release the clamping nuts (4): the belt is un-tight-
ened
5 Replace the belt
6 Fasten the clamping nut (4): the strip is tightened
7 Tighten the 4 motor attachment screws
8 Fasten the bearing flap (2) and the belt protection (1)
Further maintenance notices
• Always keep the table surfaces free of resin. Do not use
aggressive cleaning detergents!
• Remove larger grinding dust accumulations in the ma-
chine.
• Grinding belts must be rolled in towards the bearing,
DO NOT BEND!
• Grinding belts must not be suspended on nails since
this may lead to damages such as kinks or cracks.
• At the end of the working day and during longer breaks,
un-tighten the grinding belt on the machine.
Summary of Contents for 1903301801
Page 57: ...international 57 ...
