Schell 01 181 06 99, Installation Manual

Page: 17 / 24

17
Adjustment of flushing programs
Adjustment of flushing programs (only possible in the first 10 s after initiation):
as
soon as mains adaptor will be connected
(program 2 factory-made pre-adjusted)
Diagnostics LED
Red LED flashes at wide
range reflex during the first 5
minutes after initiation.
12V version: connection to power supply
For changing the flushing program of an already adjusted WC-control, the power supply must be disconnected (disconnect
external power supply unit or remove the batteries) for at least 30 s, afterwards a new programming is possible.
The device makes a selftest, then the diagnostics LED flashes 3 times quick. From that time there are 10 s for adjusting the
flushing program.
Via
close range reflex
(hold hand approx. 2 cm in front of infrared window=> see picture) it is possible to choose
between 3 different programs.
* 1 slow flash = program 1
no automatic flushing - via close range reflex only manual flushing releasable
** 2 slow flashes = program 2 (preset)
as program 1, but additional automatic flushing after leaving the WC
minimum stay time 15 s
*** 3 slow flashes = program 3
as program 2, but additional intermediate flushes every 10 min. for
handicapped areas minimum stay time 15 s
Remove hand at the desired program - the control confirms the program by flashing twice quickly.
Afterwards there are further 10 s for changing the flushing program again. After lapse of this time, the device flashes 3 times
quickly and it changes into normal function.
1.
2.
3.
4.
5.
GB