2.5 LED Display Guide
3. Functions Settings
LED Display
Meanings and Definitions
“N-L”: The system learning is not completed.
“RUN”: The system performing normally.
"CLN": The system memory is erased (factory setting).
To do so, press "UP + DOWN" simultaneously for 5 seconds
“STP”: The motor has stopped in the middle of the operating process.
“ME”: Motor operation error
“ARN”: System in learning mode. During the learning process, the display shows the value of
the required force at the respective point of the gate movement.
ATTENTION! If the drive
stops during the learning, then the factory over-current setting of "25" has been
exceeded. You will see the value on the display during system learning. The over-current
Antenna
M2-
M1-
Lat-
Lit-
Lmt4
Lmt3
Lmt2
Lit+
SKey
S1
M2+
M1+
Lat+
Ph2
Ph1 PhVcc
PhVcc
S2
5V
ANT
GND
DKey
GND
GND
GND
GND
Lmt1
GND
P190-PCB1
40121-377-A1
Q17
J5
SW1
RF-LEARN
RF1
K5
K3
K2
K1
J4
J3
J7
F1
J8
DOWN
NC
NO
CO
+
-
NC
NO
CO
+
-
-
+
CO
NO
NC
-
+
CO
NO
NC
NC
NO
CO
+
-
-
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16 17 18
19 20 21 22 23 24 25 26
LED2
LED3
LED4
LED2
LED3 LED4
3.1 Changing Setting Parameters
Step 1: Press the “Set” button for 3 seconds, the display will show the function code.
Step 2: Choose a setting via the Up and Down keys. After having chosen the desired parameter, press the Set button
and enter the setting of this function. The second digit will be shown on the right of the display, indicating the related
function (please refer below chart for details). Use the Up and Down Keys to choose the setting function and press the
Set button to save.
2.6 LED Indication Lights
LED2: is illuminated when a key-switch or push-button is activated.
LED3: is illuminated when the Photocells 1 are triggered.
LED4: is illuminated when the Photocells 2 are triggered.
setting can be set in menu F3 (see pg. 10 + 11).
“D-G / LEA”: "Dual Gate" or 2-leaf operation / waiting for a learning command
from the hand transmitter.
27
