Schaerer Ambiente 2, User Manual

Page: 85 / 130

Optional Features
7.7 Special steam
7.7.1 Special steam with automatic steam cut-off
Danger!
Never point the steam jet towards parts of your body!
„ Option:
This special steam outlet measures the temperature of the product to be heated. The
steam output automatically cuts off when the fixed temperature setting programmed by
the service engineer is reached. A timer operates in parallel to the temperature meas-
urement. Repeat the procedure if the required temperature is not attained under excep-
tional circumstances and the steam outlet cuts off nevertheless.
Two variants of this design are available.
1st variant:
Press the [ ] key briefly to heat up a full cup.
Press the [ ] key and hold it for about 2 seconds to heat up a full pot.
(The steam output can be cancelled prematurely by pressing the steam button again.)
2nd variant:
Automatically controlled steam output. Pressing the [ ] key briefly causes steam to be
output. The steam output is automatically increased to full capacity after 3 seconds.
This variant is only suitable for larger containers such as coffee pots with a capacity of
min. 500 ml.
Pressing the steam key again cancels the steam output prematurely (providing start/stop
mode is enabled).
Preparing a beverage:
1. Immerse the steam pipe into the beverage to be heated until it reaches the bottom of
the container.
2. Press the [ ] key as described above:
3. The steam output is switched off automatically when the pre-programmed tempera-
ture is reached or by pressing the steam key again. (The deeper the note, the higher
the temperature.)
4. Place the container to the side.
select product
12:00 15.10.2001
5. Clean the steam pipe with a damp cloth.
‹ Pressing the [ ] key again cancels the steam output prematurely, providing start/stop
mode is enabled.
‹ The steam pipe must remain immersed for as long as steam is being output.
‹
The beverage may start to bubble when the boiling point is reached.
‹ Steam cannot be pre-selected.
‹ Steam output is prevented during the coffee machine’s heating up phase after the sys-
tem has been switched on.
BASO-2 - 02.07 - V08
Page 7-15