Scanivalve MPS4232, Hardware And Software Manual

Page: 72 / 96

66
MPS4232
Section 5: Software
Oven Variables (LIST O)
The oven settings control the thermal chamber when performing a multi-temperature calibration or validation of the
MPS4200. These settings are only required if performing a full calibration or validation. Refer to Section 6: Calibration and
Validation Overview for more information.
List Oven Settings (LIST O)
DESCRIPTION Returns all of the oven settings
SYNTAX LIST C
RETURNS All of the oven settings followed by the prompt.
EXAMPLE
LIST O
SET IPOVEN 0.0.0.0 0
SET STARTOVEN 0
SET STOPOVEN 0
SET TEMPOVEN 0
>
Set the Oven IP Address, Port and Calibrator Number (IPOven)
COMMAND IPOVEN
TYPE Set/Get
DESCRIPTION Sets the IP address and port for the oven / thermal chamber.
SYNTAX SET IPOVEN <ipadd> <port>
Where:
<ipadd> = Calibrator IP address
<port> = Calibrator port
If 0.0.0.0 0 is set, no oven is used.
RETURNS Prompt when ready to accept a new command.
EXAMPLE
SET IPOVEN 10.0.0.122 1025
>
DEFAULT 0.0.0.0 0
RANGE These values are not range checked.
Set the Oven Start Command (STARTOVEN)
COMMAND STARTOVEN
TYPE Set/Get
DESCRIPTION Sets the command to send the oven / thermal chamber to start.
SYNTAX
SET STARTOVEN
[<start oven command>]
If no command is entered, a <CR> is sent to the oven.
RETURNS Prompt when ready to accept a new command.
EXAMPLE SET STARTOVEN RUNM
>
DEFAULT 0
RANGE These values are not range checked.