22
Remove the remaining water in drain pump To avoid burning, it
shall be done after the hot water inside the machine cools down.
Clean detergent box and grooves
Clean detergent drawer and grooves
1 Press down the arrow location on softener cover inside the
drawer.
2 Lift the clip up and take out softener cover and wash all
grooves with water.
3 Restore the softener cover and push the drawer into posi-
tion.
Clean inlet filter
Inlet filter shall must be cleaned if there is not any or insufficient
water in when the tap is opened.
Clean the tap filter:
1 Close the tap.
2 Select any procedure except
“Wash” or “Drain” procedure.
3 Press the button “Start/Pause”
and keep the procedure running
for about 40 seconds.
4 Remove the inlet pipe from the
tap.
5 Use water to wash the filter.
6 Reconnect the inlet pipe.
Washing the filter in washing ma-
chine:
1 Screw off the inlet pipe from the
backside of the machine.
2 Pull out the filter with long nose
pliers and reinstall it back after
being washed.
3 Reconnect the inlet pipe.
4 Open the tap and make sure
there is no water leakage.
5 Close the tap.
Notes: Generally, the tap filter is wa-
shed first and then the filter in wa-
shing machine will be washed.
If only the filter in washing machine
is washed, then the steps 1~3 in
cleaning the tap filter shall be re-
peated.
Pull out the power plug to avoid
electrical shock before washing.
After using the washing machine,
pull out the power cord and close
the door tightly to avoid pinching
the kids.
Remove foreign matters
Drain Pump Filter:
Drain pump filter can filter the yarns and small foreign matters
from the washings.
Clean the filter periodically to ensure the normal operation of
washing machine.
Cleaning the pump
According to the soil level within the cycles and the frequency
of the cycles,you have to inspect and clean the filter regularly.
The pump should be inspected if the machine does not empty
and/or spin; the machine makes an unusual noise during drai-
ning due to objects such as safety pins, coins etc. blocking the
pump.
1 Disconnect the appliance;
2 If necessary wait until the water has cooled down.
3 Open the service panel .Place a container close to collect any
spillage.
4 When no more water comes out, unscrew the pump cover
and remove it. Always keep a rag nearby to dry up spillage
of water when removing the cover.
5 Remove any objects from the pump impeller by rotating it.
6 Screw the pump cover fully in.
7 Close the service panel.
Warning!
When the appliance is in use and de-
pending on the programme selected
there can be hot water in the pump.
Never remove the pump cover during
a wash cycle, always wait until the ap-
pliance has finished the cycle, and is
empty. When replacing the cover, en-
sure it is securely retightend so as to
stop leaks and young children being
able to remove it.
First, drain the water with drain pump
and then open the drain pump to clean
away foreign matters from drain pump
filter.
Take care if the drained water is hot.
Proceed as follows:
Open the service panel Unscrew the
pump cover Screw the pump cover
Close the service panel
