17
Install inlet pipe
1 Connect the elbow to
tap and fasten it clock-
wise.
2 Connect the other end
of inlet pipe to the inlet
valve at the backside of
washing machine and
fasten the pipe tightly
clockwise.
Notes: after connection, if there is any leakage with hose, then
repeat the steps to connect inlet pipe. The most common type of
tap shall be used to supply water. If tap is square or too big, then
standard tap shall be changed.
Place outlet hose
There are three ways to
place the end of outlet
hose:
1 Connect it to the floor
drain.
2 Lay loose in a zink or
similar
3 Connect to the zinks
oder trap or drain.
It can drain the water up
and down, outlet hose shall
not be installed at a height
above 100 cm and it’s end
must not be immersed in
water.
The outlet hose is too long
it must not be forced into
the waching machineIf
othervise it will cause an
abnormal noise nevel.
If installed to a zink the
hose must be secured with
a string or similar to the
water tap.
Position outlet hose properly so that the floor will not be dama-
ged by water leakage.
Electrical Connection
- As the maximum current through the unit is 10A when you
are using its heating function, please make sure the power
supply system (current, power voltage and wire) at your
home can meet the normal loading requirements of the
electrical appliances.
- Please connect the power to a socket which is correctly
installed and properly earthed.
- Make sure the power voltage at your place is same to that in
the machine’s rating label.
- Power plug must match the socket and cabinet must be
properly and effectively earthed.
- Do not use multi-purpose plug or socket as extension cord.
Select the location
Before installing the washing machine, the location characterized
as follows shall be selected:
- Rigid, dry, and level surface (if not level, please make it level
with reference to the following figure “Adjust Leg”)
- Avoid direct sunlight
- Sufficient ventilation
- Room temperature is above 0 C
- Keep far away from the heat resources such as coal or gas.
Make sure that the washing machine will not stand on power
cord.
Do not install the washing machine on the carpet floor.
Adjust Leg
1 When positioning the
washing machine,
please first check if
the legs are closely
attached to the cabinet.
If not, please turn them
to their original positions with hand or spanner and tighten
the nuts with spanner.
2 After positioning the washing machine, press four corners on
top cover of washing machine in sequence. If the washing
machine is not stable when being pressed, this leg shall be
adjusted.
3 Ensure the positioning status of washing machine. Loosen
the lock nut with spanner and turn the leg with hand until it
closely contacts with the floor. Press the leg with one hand
and fasten the nut closely to the cabinet with the other
hand.
4 After being locked properly, press four corners again to make
sure that they has been adjusted properly. If it is still unsta-
ble, it has to repeat Steps 2 and 3.
5 Put a solid cylinder (e.g. pop cans) oppositely on the top
cover of the washing machine from in the left, right, front
and back directions. If the cylinder keeps stable, the washing
machine is positioned level. If it rolls, the washing machine
is positioned unlevel. The rolling direction is the direction
of lower ground surface.Then, the two legs in this direction
shall be raised at the same time until the washing machine
is level. Steps 1~3 are repeated to make the bottom legs
closely against the ground and the nuts shall be locked
tightly.
Connect inlet pipe
Connect the inlet pipe as
indicated in the figure.
For the model which has
hot valve , please connect
the hot vale to hot water
tap. Energy will decrease
automatically for some program.
