General Description of Refrigerator
1 Lamp box assembly
2 Refrigerator Glass Shelf
3 Crisper Cover
4 Salad Crisper
5 Crisper Cover
6 Salad Crisper
7 Upper Freezer Drawer
8 Freezer Room Glass Shelf
9 Bottom Freezer Drawer
10 Adjustable Foot
11 Egg tray
12 Upper Bottle Rack
13 Bottom Bottle Rack
INSTALLATION
Location
When selecting a position for your Fridge/Freezer you should
make sure the floor is flat and firm, and the room is well
ventilated with an average room temperature of between
16°C and 38°C. Avoid locating your Fridge/Freezer near a
heat source, eg. cooker, boiler or radiator. Also avoid direct
sunlight in out-buildings or sun lounges. If you are placing
your Fridge/Freezer in an out-building such as a garage or
annex ensure that the Fridge/Freezer is placed above the
damp course, otherwise condensation will occur on the
Fridge/Freezer cabinet. Never place the Fridge/Freezer in a
wall recess or into fitted cabinets or furniture. When your
Fridge/Freezer is working, the grille at the back may become
hot and the sides warm. It must therefore be installed so that
the back of the Fridge/Freezer has at least 9cm (31/2”)of
free space and the sides have 2cm (3/4”).Do not drape the
Fridge/Freezer with any covering.
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal
alignment will be affected and may cause you Fridge/Freezer
to work incorrectly. Once the Fridge/Freezer is placed in its
final location, adjust the leveling feet at the front by turning
them.
Cleaning before use
Wipe the inside of the Fridge/Freezer with a weak solution of
bicarbonate of soda. Then rinse with warm water using a
damp sponge or cloth. Wash the baskets and shelves in warm
soapy water and dry completely before replacing in the
Fridge/Freezer. The external parts of the Fridge/Freezer can
be cleaned with wax polish.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the
plug supplied with the Fridge/Freezer.
Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE
FRIDGE/FREEZER.
The coolant fluid needs time to settle. If the appliance is
switched off at any time, wait 30 minutes before switching
back on to allow the coolant fluid to settle.
Before filling your Fridge/Freezer
Before storing foods in your Fridge/Freezer, turn the
Fridge/Freezer on and wait for 24 hours, to make sure it is
working properly and to allow the Fridge/Freezer to fail to
the correct temperature.
Electrical Connection
~WARNING~
Improper use of the grounded plug can result in the risk of
electrical shock. If the power cord is damaged, have it re-
placed by an authorized service center.
This refrigerator should be properly grounded for your safety.
The power cord of this refrigerator is equipped with a three-
prong plug which mates with standard three prong wall out-
lets to minimize the possibility of electrical shock.
Do not, under any circumstances, cut or remove the third
ground prong from the power cord supplied.
This refrigerator requires a standard 220 -240V A.C. ~/50Hz
electrical outlet with three-prong ground.
This refrigerator is not designed to be used with an inverter.
The cord should be secured behind the refrigerator and not
left exposed or dangling to prevent accidental injury.
Never unplug the refrigerator by pulling the power cord.
Always grip the plug firmly and pull straight out from the
receptacle.
Do not use an extension cord with this appliance. If the power
cord is too short, have a qualified electrician or service techni-
cian install an outlet near the appliance. Use of an extension
cord can negatively affect the performance of the unit.
START
Control system schemes
1 Control mode: the mode of Air Cooling Electronic Control
uses the control card and the temperature sensor to col-
lect temperature difficult to control; the control plate is at
the back of the device; the display panel is in the Upper
compartment of the refrigerator, Mechanical Keys taken
and uses LED Light.
2 Control Panel: adopted the Model switched power supply
with output loads, including Compressor, heater, Motor
and the LED Lamp, etc., and the entry charges, including
the sensor, the refrigerator defrosting sensor, The Switch
of the lamp the door, and the keys of the screen display.
3 Spring and autumn loop temperature between 16-35
℃
,
temperature SET adjusted to 4 or 6-speed, air volume
control lever can be placed in the middle position.
4 Summer (especially the temperature above 35
℃
), tem-
perature was adjusted to 2 SET gear, air volume control
lever to the intermediate region between the maximum
5 Winter (16
℃
temperature and below) to adjust the
temperature SET 2 files, air volume control lever to the
intermediate region between the minimum and, prefera-
bly a minimum or near minimum position.
