5. Install the phone
If you have installed the stand and are using the
phone on a desk:
Turn the telephone over so it rests on the stand.
Connect the phone cord to a phone jack and plug the
power adapter into a power outlet.
1
6. Install the phone on a wall
A. Connect the cord to the wall jack.
2
B. Coil the phone cord into the space provided on the
back of the phone.
C. Align the telephone so the hooks on the wall plate
align with the wall-mount slots on the back of the
phone, as shown here.
D. Push the phone onto the pegs, and then slide it
down until it is secure.
E. Plug the power adaptor into a power outlet.
1
390/480 Phone for AltiGen User Guide
3
Installation
2. Attach the stand
If you plan to mount the phone on the wall, you do not
need to attach the stand; skip this step. If you plan to
use the phone on a desk, attach the stand by inserting
the tabs on the stand (marked with
) into the slots on
the bottom of the telephone. For a higher viewing
angle, use the slots marked
. For a lower viewing
angle, use the slots marked
. Then rotate the stand
towards the phone until it snaps into place (
B
).
3. Connect the cords
If you attached the stand to install the phone on a
desk,
route both the phone cord and power adapter
cord through the opening in the stand. Insert the phone
cord into the slot on the back of the telephone
marked
until it clicks into place. Insert the power
cord into the power jack marked
.
4. Press the cords into grooves
Press the cords into two of the grooves provided on
the bottom the stand so that the stand will sit flat on a
desk.
390/480 Phone for AltiGen User Guide
2
1
Note
: You should connect the power adaptor to a surge protector
or power bar.
2
Note:
You may wish to purchase a short phone cord from a local
supplier for a wall installation.