BIOCLIMATIC PERGOLA
4.4
CENTRAL PROGRAMMING OF 1 MOTOR (factory set up)
my
<
<
V
+ V
=1/2s
PROG.
+
_
+
_
MOTOR
24 Vdc
CLAK-CLACK
CLAK-CLACK
CLAK-CLACK
Close programming
clack-clack
Close programming
clack-clack
DELETION OF PROGRAMMING
Hold the A button until the third
.
clack-clack (12s)
DELETION OF PROGRAMMING
Hold the A button until double
.
clack-clack
Briefly press (0,5 s)
Press PROG.
Up to clack-clack
FEED MOTOR (24 VDC)
EXPECT A CLACK-CLACK
PROGRAMMING REMOTE CONTROL
PROGRAMMING FROM RECEIVER
SCREWS HARDNESS CATEGORY 70
THREAD
µges.
MA TIGHTENING
TORQUE
(Nm)
M5
0,2
5,7
M6
0,2
10
M8
0,2
24
05
MAINTENANCE
For best use and extended durability of your pergola, it is recommended to carry out regular maintenance and services at
least once a year, or even more often depending on the wind fatigue at the installation site.
To prevent corrosion, it is recommended to periodically clean gutters and sections with neutral soap. The minimum fre-
quency is once a year, and must be increased for cloths exposed to aggressive environments (marine, industrial, airborne
dust particles, etc.). It is important to rinse thoroughly with water, after using detergents, to avoid the formation of salts
on the surface of the sections.
When properly done, this periodical cleaning removes from the
surface of the cloth the exogenous agents that can attack the
coating and aluminium, extending the life of the sections and their
aesthetic performance.
Inspection of seals, revision of the electrical installation, as well
as a review of the tightening of screws according to the tightening
torques (standard metric thread) set forth in the attached table.
PROG.
+
_
+
_
MOTOR
24
Vdc
