Section 5: Troubleshooting
Page 5-4
CW408 Operator Manual
5.1 ERROR SIGNAL TROUBLESHOOTING (Cont’d)
5.1.3 More Information about Command Error
Printer motion when detecting command error
When DISPLAY ERROR is set to ENABLE in Advance settings mode, the
printer displays the information of a command in which error was detected.
This information is displayed at the bottom of the screen. The printer stopped
the printing.
This error can be cleared by pressing the
LINE
button, but the data in which
an error was detected will be discarded and not print.
Position of error occurrence
“
Caaa
” in error message shows location of the command where error was detected.
“
aaa
” shows the number of ESC command from ESC+A, but the number does not include ESC+A.
The number displayed in
aaa
is up to 999, and the number beyond 999 is displayed as 999.
Example)
When a command error is detected by Horizontal Print Position <H> command.
------- :
[ESC]A
C001 :
[ESC]V100
C002 :
[ESC]H99999
-> Location of command error
C003 :
[ESC]L0202
C004 :
[ESC]X2,ABCDEF
C005 :
[ESC]Q1
C006 :
[ESC]Z
In this case,
C002
is the location of error.
Name of error command
<
bb
> in error message shows a name of command where error was detected.
* When it is 1 byte command, it will be left aligned.
No.
ERROR DISPLAY
LED/ BUZZER
ERROR CONDITION
CORRECTIVE ACTION
38
SET MEDIA ERROR
ONLINE: On
ERROR: Off
Message: SET MEDIA
3 short beeps
1) No media in the printer.
2) Media is not loaded
correctly.
3) Incorrect pitch sensor
level.
To clear error: Feed media
1) Load media into the printer.
2) Load media properly.
3) Adjust the pitch sensor level.
SET MEDIA
Command information in
which a command error
was detected
ERROR27
INVALID DATA
Caaa:<bb>:cc
Preliminary