1
Introduction
Thank you for purchasing the Temperature/Humidity Indicator, SK-M350-TRH-I.
- This is an indicator which displays the temperature and humidity by inputting a direct current 4 to 20mA.
SK-M350-TRH-I can be connected to a 4 to 20 mA output device or our temperature/humidity
transmitter model SK-RHC-I. Do not use this instrument for any other purposes
- Read this instruction manual thoroughly before use and keep it in a safe place for future references.
Warning
DANGER
RISK OF EXPLOSION
- These instruments are not explosion-proof. Never use them in environment with flammable gases.
- For any inquiries, contact the store where you bought the instrument or our service network.
Cautions
■ Please follow the instructions below for proper usage of the product.
- Never disassemble or modify the instrument. Doing so may cause malfunctions.
- These are precision instruments. Be careful not to drop, vibrate or give an impact to them
- Avoid using the instruments in a place exposed to direct sunlight or near a heat source.
Doing so may not just compromise the measurements but cause failures as well.
- Avoid using the instrument in dusty environment or salty air. Dust and dirt on the power plug may
cause fire.
- This instrument is not waterproof. Never let it wet.
- Do not use it in places in effects with condensing, rain, water drops or steam.
- If this instrument is used in an environment where electrical noise is generated, the display may
become unstable and the measurement error may increase.
- Refer to the 'Installation Method' section of this manual when installing the instrument and be careful
not to drop.
- Remove all electrical wirings before moving the instrument. Fail to do so may cause dropping of the
instrument.
- Make sure to select a proper type of adaptor in accordance with related standards and product
specifications when not using the accessory device that comes with the instrument.
The standards and specifications are stated in the 'AC adaptor' section of this manual.
■ Please follow the instructions below to avoid electric shocks.
- No power switch is available for this instrument. Therefore the instrument becomes its operation
state when connected to a power source.
- Connect to a power source only after correct wiring is complete.
- Do not touch the terminals while power is being supplied.
- Do not wire the instrument in places with heavy humidity or water splash nor with wet hands.
- Make sure to put the terminal cover on during usage time in prevent from dust or an electric shock.
■ Please contact the distributor where the purchase was made or our service network for any repair or
calibration of the instrument.
