Version
3.3
32
10. Send settings to modem. SATEL Configuration Manager. DTE one-by-one
Settings to the modem can be sent by the SATEL Configuration Manager. The DTE can send
settings one-by-one or by using a special exe-command.
11. Channel Scanning feature. DTE
When activated, the modem scans channels one by one and saves the RSSI-readings to
memory. The respond to the DTE is: 1
st
RSSI, 2
nd
RSSI, 3
rd
RSSI and so on.
12. Search Free channel. DTE
When activated the modem searches for the next channel which is free from traffic. The listening
time of the traffic is about 2 seconds. The response is “channel xx is free”. By activating same
command again, the modem shows the next free channel.
13. Assign Frequencies to channel numbers. SATEL Configuration Manager
All possible frequencies, which are available by the modem type, are listed in the SATEL
Configuration Manager. The user can pick up a maximum of 40 frequencies and assign them
channel numbers.
14. Set Channel Spacing. SATEL Configuration Manager
Channel spacing must be assigned to the list or every channel separately. The alternatives are
12.5 kHz, 20kHz or 25 kHz.
Note that there can be only one channel spacing alternative per channel.
15. Addressing. SATEL Configuration Manager
Defines addresses to the receiver and transmitter.
16. Configure communication port parameters. SATEL Configuration Manager and DTE
Configurable parameters are Baud Rate, Parity, Number of Data Bits, Number of Stop Bits.
17. SLEEP. DTE
Special SL-command, SL+S=1 (which shuts down power units, synthesisers, and processor to a
low power sleep mode)
Waking up from SLEEP is done if by sending a character to the modem. Wake-up time is about
40ms, before the modem is ready to receive data.
18. Set FEC. SATEL Configuration Manager
Sets the Forward Error Correction ON/OFF.
19. Print actual settings from modem. SATEL Configuration Manager
Reads settings from modem and makes it possible to print settings a list.
20. Additional settings (auto baud rate detection…) Optional. SATEL Configuration
Manager
When activated, the PC will start polling the modem (HW-version) with different baud rates, and
other values. When recognised the PC knows modem’s port settings. The response is “modem
found on port” or no modem found.
