Version
3.3
27
Other radio related Effect and description of command
25
SL@R?
Display field strength of the last received message (the value is an average
of many measurements made during the same reception).
Response ”-xx dBm”, where xx is a decimal value of the field strength and
it is between –80 dBm and –118 dBm. Value available 7s after reception.
SATELLINE-3AS Epic returns the stronger value of two receivers.
26
SL@P=xxxxx
Set the RF output power, where xxxxx is the decimal value of the intended
power in mW. If the given value does not correspond to one of the
programmed power levels, the output power is set to the nearest possible
value.
27
SL@P?
Requests the RF-output power.
Response ”xxxxx mW”, where xxxxx is a decimal value the output power of
the transmitter.
28
SL@T=-xxx
Set the minimum power level of the signal to be received (="Signal
Threshold level), where xxx is a decimal value of the new intended level in
dBm.
29
SL@T?
Request the current "Signal Threshold Level". Response is "-xxx dBm.
30
SL@G=1
Switch to GSM-mode (Note: No response message follows the command)
31
+++SL@G=0
Switch to UHF-modem mode.
32 SL@X=1
Reset
the
BT-module
32.1
SL@X=9
Reset modem. Shuts down the modem. Does not retrieve “ok”.
32.2
SL@S=0
Set Satel 3AS (default)
32.3
SL@S=1
Set Option 1 (PCC-4FSK)
32.4
SL@S=2
Set Option 2 (PCC-GMSK)
32.5
SL@S?
“0” if the modem is in SATEL 3AS-mode
“1” if the modem is in Option 1-mode
“2” if the modem is in Option 2-mode
FC -related
Effect and description of command
33 SL!M?
Show the FCS-mode of the modem. The reply is ‘O’ if FCS is turned OFF,
‘M’ for a master (=transmitter) and ’S’ for the slave (=receiver).
34
SL!O?
Return beacon sending disable timeout
35
SL!O=
Set the beacon sending disable timeout. Time is in seconds. If it is zero
then beacon is never disabled.
If timeout is less than beacon timeout, modem will not send additional
beacons.
36
SL!D?
Return the lower limit for band 1
37 SL!U?
Return
the
upper limit for band 1
38
SL!W?
Return the lower limit for band 2
39
SL!Y?
Return the upper limit for band 2
40
SL!I?
Return the FCS Net ID
41
SL!I=
Set the FCS Net ID
42
SL!R?
Return the RX listen timeout
43
SL!R=
Set the RX listen timeout
44
SL!B?
Return the Beacon interval
45
SL!B=
Set the Beacon interval
46
SL!C?
Return the number of used channels
47
SL!C0
Clear the number of used channels
48
SL!F?nn
Return the frequency of channel nn
49
SL!F=
Add a new frequency to list
