SATEL PERFECTA
33
8.1 SATEL server
PERFECTA Control conn. via SATEL server allowed
[PERFECTA CONTROL] – if this
option is enabled, it is possible to establish connection between the PERFECTA
C
ONTROL
application and the control panel through the SATEL server.
Push notifications
[PUSH messages] – if this option is enabled, the PERFECTA
C
ONTROL
application can provide information about alarm system events by means of push
notifications.
PERFECTA Soft conn. via SATEL server allowed
[PERFECTA Soft] – if this option is
enabled, it is possible to establish connection between the PERFECTA
S
OFT
program and
the control panel through the SATEL server.
Make sure that the SIM card tariff plan is suited to the requirements of communication
via the SATEL server (GPRS connection to the server is active at all times).
8.2 Direct connection to PERFECTA S
OFT
PERFECTA Soft address
[041.Address] – address of the computer running the PERFECTA
S
OFT
program. It must be a public address. You can enter the IP address or domain name.
Port
[042.Port] – number of the TCP port used for direct communication between the control
panel and the computer with PERFECTA
S
OFT
program via GPRS. You can enter values
from 0 to 65535 (0=disabled).
SMS initiating connection
[115.PERF.Soft] – control command which will be sent in SMS
message to initiate communication between the control panel and the PERFECTA
S
OFT
program. You can enter up to 8 alphanumeric characters (digits, letters and special
characters). You can enter spaces, but at least one character must be different from the
space.
The command content must be different from that of the other control commands
preprogrammed in the control panel.
In the SMS message, you can include address of the computer the control panel is to
connect to, and the number of TCP port which is to be used for communication.
9. Reporting
The control panel can send event codes to the monitoring station by using the following
transmission paths:
GPRS,
SMS messages (control panel gets no acknowledgement of event code receipt),
GSM voice channel (the use of this transmission path is not recommended because of
distortions that may occur when sending the event codes).
9.1 Reporting parameters and options
Reporting
[Monitoring] – if the option is enabled, the control panel can send event codes to
the monitoring station.
Reporting mode
[72.Stations] – defines how event codes are to be sent to the monitoring
stations:
Station 1 or station 2
– the control panel will make an attempt to send the event code to
station 1 and, if unsuccessful, to station 2.
