SATA SATAjet 100 B F RP, Operating Instructions Manual

Page: 145 / 584

145
EN
Operating Instructions SATAjet 100 B F (RP / HVLP), B P Operating Instructions SATAjet 100 B F (RP / HVLP), B P
Note!
In rare cases, it may be necessary to dismantle some parts of the spray
gun to clean them thoroughly. If dismantling should be necessary, this
should be limited just to the parts whose function brings them in contact
with the material.
■ Purge spray gun thoroughly with thinner.
■ Clean air cap with a paint brush or brush.
■ Lightly grease moving parts with high performance grease.
11. Malfunctions
The malfunctions described below may only be remedied by trained per-
sonnel.
If it is not possible to remedy a malfunction with the described corrective
actions, send the spray gun to the SATA customer service department
(address see chapter 16).
Malfunction Cause Corrective Action
Jerky spray fan pat-
tern (wobbling / splut-
tering) or air bubbles
in the gravity flow cup.
Fluid tip not tightened. Tighten fluid tip with
universal spanner.
Air distribution ring
damaged or clogged.
Replace air distribution
ring (see chapter 9.2).
Air bubbles in gravity
flow cup.
Loose air cap. Tighten the air cap
hand-tight.
Gap between air cap
and fluid tip (air circuit)
is clogged.
Clean air circuit. Heed
cleaning instructions
(see chapter 10).
Nozzle set is soiled. Clean nozzle set. Heed
cleaning instructions
(see chapter 10).
Damaged nozzle set. Replace nozzle set (see
chapter 9.1).
Not enough material in
gravity flow cup.
Fill gravity flow cup (see
chapter 8.2).
Defective paint needle
seal.
Replace paint needle
seal (see chapter 9.3).