![background image](http://html.mh-extra.com/html/sata/filter-100-prep/filter-100-prep_operating-instructions-manual_1200259067.webp)
67
EN
Operating Manual SATA filter 100 / 101 / 103 prep
Operating Manual SATA filter 100 / 101 / 103 prep
Warning! Attention!
•
When the compressed air is heavily contaminated, the filter
cartridges have to be exchanged in shorter intervals!
• Saturated filter cartridges may cause quality problems during paint
jobs. Furthermore, using a supplied-air respirator could become harm
-
ful, causing permanent health damage and even death!
• Depressurise filter (close shut-off tap)
•
Unscrew
[3]
the respective filter housing with the pin spanner included
in the delivery.
• Remove condensate cyclone separator
[4-1]
from the filter stage
[A]
, remove and check insert as well as sintered filter
[4-2]
. Clean or
replace if necessary
• Remove
[4-3]
and replace fine or activated charcoal cartridge on filter
stages
[B]
and
[C]
• Installation has to be carried out in reverse order. Please make sure
that the filter cartridges are installed in the correct order. Coloured
markers (yellow = sintered filter
[A]
, blue = fine filter
[B]
, black = acti-
vated charcoal filter
[C]
allow clear identification
[4-4]
. Marking rings
are located on the threaded rods of the filter stages
[B]
and
[C]
.
•
During installation, please ensure proper seat and undamaged O-rings!
Note!
Please observe local regulations for the disposal of filter cartridges!
11. Troubleshooting
Malfunction
Cause
Corrective action
Pressure cannot be
properly adjusted
Insufficient inlet pres
-
sure
Increase inlet pressure
Pressure regulation
valve at air outlet mod
-
ule is defective
Exchange air outlet
module [D], Art. No.
148239
BAL-SATA filter 100-101-103 prep.indb 67
12.11.2015 15:18:20