Sanyo PLC-XK3010, Owner'S Manual

Page: 17 / 77

17
Connecting the AC Power Cord
This projector uses nominal input voltages of 100-40 V
AC and it automatically selects the correct input voltage.
It is designed to work with single-phase power systems
having a grounded neutral conductor. To reduce the risk
of electrical shock, do not plug into any other type of
power system.
If you are not sure of the type of power being supplied,
consult your authorized dealer or service center.
Connect the projector with all peripheral equipment
before turning the projector on.

Note :
Unplug the AC power cord when the
projector is not in use. When this projector
is connected to an outlet with the AC power
cord, it is in Stand-by mode and consumes
a little electric power.
Connect the AC power cord
(supplied) to the projector.
To the AC outlet.
(200 - 240 V AC)
To power cord
connector on your
projector.
Projector side AC outlet side
To the AC outlet.
(120 V AC)
For the U.S.A. and Canada
To the AC outlet.
(200 - 240 V AC)
For Continental Europe
Ground
For the U.K.
NOTE ON THE POWER CORD
AC power cord must meet requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.


Ground
The AC outlet must be near this equipment
and must be easily accessible.
CAUTION
Installation