Sanyo ECO G SGP-EW120M2G2W, Technical Data Manual

Page: 7 / 115

Outdoor Unit
1. Conditions for gas use
B-3
(5) When using Propane
* When using Propane as the gas fuel, it is necessary to adjust the fuel adjustment valve and the gas
type setting.
(1) Fuel valve setting
● With the power supply breaker for the outdoor unit
OFF
1) Move the lever of the P/N switch that is attached to the
mixer part of the engine to the position shown in the
diagram. Turn it 180 degrees in the clockwise direction
(there is a stopper provided). Do not apply unnecessary
force to turn it any further.
2)
In
the electrical equipment box, fix the "Gas type
setting/Adjustment Completed" label to the
prescribed position for the PL NAME.
(2) Fuel Gas Type Setting
● Check that the fuel adjustment valve setting has
been set before operating the outdoor control board.
1) Press the home key (S004) for longer than one second and the menu item number will be displayed.
2) Next, press the up (S005)/down (S006) key to set the menu item number to .
3) After displaying , is displayed. When is displayed press the set
(S007) key. The green LED (D053) lights up, and the system address setting is displayed.
(For example:
)
4) Next operate the down (S006)/up (S005) key, to display the gas type setting. When the gas
type setting is displayed, press the set (S007) key for longer than one second.
Note: When setting the gas type, ** is displayed.(for ** enter 00-05)
5) A red LED (D052) lights up, indicating that a forced setting is being carried out. In this condition, press
the down (S006)/up (S005) key, and select the gas type.
The relationship between display and gas type is as shown in the following table.
Display Gas type
(GAS 00) Propane G31
(GAS 01) -
(GAS 02) Natural gas G20
(GAS 03) Natural gas G25
(GAS 04) -
(GAS 05) -
(GAS 06) -
(GAS 07) -
(GAS 08) -
(GAS 09) -
(GAS 0A) -
(GAS 0b) -
(GAS 0C) -
(GAS 0d) -
(GAS 0E) -
↑ Up key
(S005)
↓
Down key
(S006)
(GAS 0F) -
* When the H/L/E gas type is selected, the oil replacement time warning is not displayed.
6) After completing selection of gas type, press the set (S007) key for longer than 1 second. The red LED
(D052) will be extinguished.
7) Press the home (S004) key to complete the setting.
Note: When using propane, change the setting in accordance with the above procedure to