LIVE settings
33
2
Select the setting position (4 positions) using the control
button (
}~
).
3
Select the input terminal number (1 - 16) using the control
button (
{|
).
☞
In DSR-2108, input terminal number (1 - 8).
4
Press the ENTER button.
●
Setting the VIDEO LOSS ON
An alarm signal is output when the specified video input
terminal receives a VIDEO LOSS occurs.
1
Select "
VIDEO LOSS ON
" using the control button (
{|
).
2
Select the setting position (4 positions) using the control
button (
}~
).
3
Select the input terminal number (1 - 16) using the control
button (
}~
).
☞
In DSR-2108, input terminal number (1 - 8).
4
Press the ENTER button.
●
Setting the HDD ERROR
An alarm signal is output when a hard disk error occurs.
1
Select "
HDD ERROR
" using the control button (
{|
).
2
Select output ON or OFF using the control button (
}~
).
●
Setting the ALARM DURATION
Sets the duration of the alarm output signal.
1
Select "
ALARM DURATION
" using the control button
(
{|
).
2
Select the output duration (3 - 255 seconds) using the
control button (
}~
).
4
Select "ALARM IN NO." using the control button
(
{|
) and specify the alarm input terminal number
(1-16) using the control button (
}~
).
Setting the signal polarity of the specified alarm
input terminal.
☞
In DSR-2108, input terminal number (1 - 8).
●
Setting the TYPE
1
Select "
TYPE
" using the control button (
{|
).
2
Set the signal polarity using the control button (
}~
).
---:
Does not react
N/OPEN (Normal Open):
Normally open, reacts when closed
N/CLOSE (Normal Close):
Normally closed, reacts when opened
Sets the output conditions of the monitor video terminal
(MON2).
1
Select "MON2-OUT" using the control button (
{|
)
and press the ENTER button.
The MON2-OUT screen is displayed.
2
Setting the output conditions of the MON2 terminal
●
Setting the MON2 TYPE
Sets the output screen layout of the MON2 terminal.
1
Select "
MON2 TYPE
" using the control button (
{|
).
2
Select the screen layout using the control button (
}~
).
FULL:
Single-screen output
QUAD:
Quad-screen output
●
Setting the MON2 ON EVENT
Sets whether the video of an event is output to the MON2
terminal while it is being recorded.
1
Select "
MON2 ON EVENT
" using the control button (
{|
).
2
Select ON or OFF using the control button (
}~
).
ON:
The video of the event is output.
OFF:
The video of the event is not output.
●
Setting the MON2 EVENT DWELL TIME
If "
MON2 ON EVENT
" is set to ON, set the output duration of
the video of the event.
1
Select "
MON2 EVENT DWELL TIME
" using the control
button (
{|
).
2
Set the output duration (1 - 10 seconds) using the control
button (
}~
).
E
F
Setting the MON2 (Monitor2)-OUT
MON2-OUT
MON2 TYPE
FULL
MON2 ON EVENT
ON
MON2 EVENT DWELL TIME
10 SEC
SEQUENCE
OFF
SEQUENCE-DWELL TIME
10 SEC
MON2 CHANNEL
1
L8HBT_WA(DSR-2116_2108)(GB).book 33 ページ ２００９年５月２７日 水曜日 午後４時５０分
