SY75C Excavator OMM
Engine Procedures
SANY
Operation and Maintenance Manual — 0220
4-11
TABLE OF
CON
T
ENT
S
INT
R
ODUCT
ION
SA
FETY
MA
C
H
INE
CONTROLS
MA
C
H
INE
OPERA
T
ION
MAINTENAN
C
E
SPECIFICA
T
IONS
OP
T
ION
AL
EQUIPMENT
Jump-Start the Engine
WARNING!
When working with any open electrical power circuit, ensure that your hands are free of any
metal objects (rings, watches, jewelry, etc.) that could come in contact with electrical power
points. Failure to observe and follow this warning could result in death or injury.
CAUTION!
Before proceeding with any battery maintenance procedure, remember and follow these
points:
•
Battery gases are explosive. Never smoke around batteries or expose them to sparks or
open flames.
•
Wear personal protective equipment when working with batteries.
•
Work in a well-ventilated area.
•
If battery acid contacts your skin or your eyes, flush the area immediately with fresh
water and seek medical attention.
Failure to observe and follow this caution could result in injury.
NOTICE!
The starting system voltage and the battery voltage in the boosting machine should be no
more than 24V. Never use a welder or equipment with a higher voltage system to jump-start
the machine. Using a higher voltage to jump-start the engine may damage the electrical
system or cause an unexpected explosion or fire. Always jump-start the engine with equal
voltages.
The jumper cables and their clamps must be undamaged, have no corrosion and be suitable
for the amperage. All clamps must be securely attached to their jumper cable ends.
Set all controls to their neutral positions.
Be careful when disconnecting jumper cables after both engines are running. Never allow
the jumper cable clamps to touch each other.
Failure to observe and follow this notice could result in damage to the machine or cause the
machine to operate improperly.
Summary of Contents for SY75
Page 2: ......
