SY75C Excavator OMM
Maintenance Procedures
SANY
Operation and Maintenance Manual — 0220
5-21
TABLE OF
CON
T
ENT
S
INT
R
ODUCT
ION
SA
FETY
MA
C
H
INE
CONTROLS
MA
C
H
INE
OPERA
T
ION
MAINTENAN
C
E
SPECIFICA
T
IONS
OP
T
ION
AL
EQUIPMENT
Batteries - Check
1. Locate the batteries under cover (a) behind the left rear
door.
2. Remove two nuts and washers (b) securing the cover
over the batteries.
3. Check the top surfaces and all battery connections (c)
for signs of corrosion or dirt build up. Use a clean rag to
wipe any dirt from the batteries.
NOTE:
If corrosion is found, flush the area with a
battery cleaning solution.
4. Remove any trash, tools, parts or debris from the battery
compartment.
5. Check the battery cables for looseness, tighten as
necessary.
6. Reinstall cover (a) and the fasteners.
7. Close the left rear door.
CAUTION!
Before proceeding with any battery maintenance procedure, follow and remember these
points:
• Battery gases are explosive. Never smoke around batteries or expose them to sparks or
open flames.
• Wear personal protective equipment when working with batteries.
• Work in a well ventilated area.
• If battery acid contacts your skin or your eyes, flush the area immediately with fresh water
and seek medical attention.
Failure to observe and follow this caution could result in minor or moderate injury.
Fig. 5-9
a
b
Fig. 5-10
c
c
Summary of Contents for SY75
Page 2: ......
