53
Behavior after detection
Operation
stops:
The unit stops operation, displays an error code, and outputs the external
warning relay signal according to the setting of [F6: Error output destination
selection].
Operation
continues:
The unit displays an error code and outputs the external warning relay signal
according to the setting of [F6: Error output destination selection]. The unit
continues operation.
Recovery method
Power
OFF:
Stop the power supply and remove the causes of the detected error.
Operation resumes when power is supplied again. Stopping the power supply
turns the external warning relay output OFF.
※
Errors may be detected again if the power is turned back ON without
first removing the error causes. The unit may be damaged if it
repeatedly stops due to errors.
Automatic
recovery:
The unit resumes operation when the causes of the detected error are
removed. The external warning relay output is also turned OFF.
Relay output destination
The above table shows the default values specified with [F6: Error output destination
selection].
Relay (1):
The signal is output between 1A and 1C on the control terminal block.
Relay (2):
The signal is output between HA and HC on the control terminal block.
None:
The signal is not output to the external warning relay on the control terminal
block.
Error history
Errors that occur in certain situations are not added to the history.
Summary of Contents for CALPOTE UG Series
Page 94: ...94 APPENDIX B PANEL TRANSITION DIAGRAM...
Page 96: ...MEMO...
