Sanitas SPM 11, Instructions For Use Manual

Page: 24 / 68

24
10. Wake alarm mode
• You can switch the hourly signal on and off in wake alarm mode using the reset button. If the
hourly signal is activated, the bell symbol appears in the display and a signal sounds every full
hour.
• You can switch the wake alarm on and off in wake alarm mode using the start/stop button. If
the wake alarm is activated, a symbol appears and the alarm sounds at the given time for 30
seconds. Press any button (except the light button) to stop the alarm.
setting alarm time
• You are in wake alarm mode.
• Hold the MODE button down for 3 seconds in order to enter setting mode.
• The hours display starts flashing. Now you can set the hours using the Start/Stop button and the
Reset button. Hold the button depressed to enter fast mode.
• Press the MODE button to confirm input and advance to the next setting. Enter minutes in the
same way.
• Once all data has been set, press the MODE button for 3 seconds to exit setting mode. If
no button is pressed in setting mode within 60 seconds, the heart rate monitor automati-
cally reverts to time display.
11. stopwatch mode
• You are now in stopwatch mode.