(8) 1200 PSI Hard Surface Extractor
1200 PSI Hard Surface Extractor (33)
4.0 Prepare Unit for Use
DO NOT USE ON WET SURFACES. DO NOT EXPOSE TO RAIN. STORE
INDOORS.
• All hard surface extractors, no matter what the time of year, are shipped with
antifreeze in the solution lines. Prior to first use, fill the solution tank with one quart
of warm water. Attach the hose and using a hand tool or wand, flush out the system by
spraying the one quart of water through the pump.
• Attach the vacuum hose and the brass quick disconnect.
• Fill the solution tank with warm water (less than 100 degrees Fahrenheit). Fill to
approximately 4 inches from the top. Pre-spray and agitate the surface with detergent
made for floor cleaning or upholstery. Use only warm water to extract the pre-spray
from the surface.
• Be sure to replace any filters back into the machine prior to use.
• Do not use citric acid, butyl glycol or harsh degreasers inside the machine.
4.1 Automatic Chemical Feed
WARNING: THE HARD SURFACE EXTRACTOR IS DESIGNED FOR US
WITH WATER-BASED CLEANING SOLUTIONS, SUCH AS LOW-FOAMING
DETERGENTS OR ACID RINSES. Never use dry solvent solutions. The use of
dry solvents in your extractor will void the warranty.
Chemical Metering:
the Hard Surface Extractor is equipped with an automatic
water fill/chemical feed metering system. As the solution tank fills with water, cleaning
concentrate is drawn into the solution tank at a designated rate, via metering tip. A
complete set of metering tips are included.
Metering Tip Replacement:
to adjust the amount of cleaning concentrate being
drawn, simply remove the plastic supply tube from the chemical feed metering valve
(Figure 1). Continues on the next page.
11.0 Base with Vacuum Components Parts List
Drawing No.
Item No.
Description
Quantity
39
10-0848-B
1-1/2” 90 Degree ABS Street Elbow
4
40
80-0003-A
1-1/2” Black Lined Gray Hose
2
41
SN-12-MFLD
Extractor Motor Manifold
2
42
10-0836
19” Axle for Extractor
1
43
10-0807
Wheel for Extractor
2
44
10-0820
End Cap for Extractor Axel
2
45
10-0419-A
Screw for Extractor Hatch
6
46
10-0822
Exhaust Grate
3
47
10-0808
Caster for Extractor
2
48
10-0816
1/4-20 - 1/2” Hex Caster Bolt
8
49
10-1030-S2
2-Stage Extractor Motor Gasket
1
50
10-0204
Motor Mount Back-Up Washer
6
51
10-0811
2-Stage Extractor Motor
1
52
10-0833-L
Manifolt Bolt 10-32 x 1/4” Hex Screw
6
53
T-A001
Cooling Duct
2
54
10-0810
3-Stage Extractor Motor
1
55
80-0116
Spacer for Extractor Motors
6
56
10-0155
Straight Hose Cuff
1
57
10-1030-S3
3-Stage Extractor Motor Gasket
1
https://harrissupplyind.com - To Order Parts Call 608-268-8080
