Installation on S&C Mounting Pedestals
Step 33
Attach
B\,
–11 hex nuts to the studs and tighten
them to a torque of 70 to 80 ft.-lbs. Use a flat
washer and a split washer on each stud. See
Figure 35.
Ç
CAUTION
Never exceed the recommended torque limit .
Damage to the pole-unit may occur.
Step 34
Remove the hoist sling or lifting device from
the pole-unit.
Figure 35. Tighten the nuts.
Pole-unit base
Mounting
bracket
Cross base
Pedestal
Tabs
Tabs
Figure 36. Bolt the tabs of the control cabinet to the pedestal.
Mounting the Control Cabinet
Step 35
Attach the control cabinet to the pedestal along
which the conduit will run. Align the control
cabinet tabs with the mounting holes in the
pedestal. Then bolt all four tabs to the pedestal,
using the
C\,
–16
3
9 carriage bolts furnished. See
Figure 36.
S&C Instruction Sheet 731-502
21