O p e r a t i o n
Circuit Breaker
The Circuit breaker turns off the brush rolls if there is an obstruction in them. When tripped, the circuit breaker
button(RESET BUTTON) will pop up, and the brush roll control button will light up.
The brush rolls will not turn, but the suction motor will continue to run. To reset the breaker, turn cleaner off and
unplug it, clear obstruction, press circuit breaker button down. Turn cleaner ON and continue cleaning.
Powerfoot Height Adjustment
1
Place Handle in Upright Position.
2
Turn Height Adjustment Knob to desired setting.
Lowest Setting - For bare floors.
Medium Settings - For short and medium pile carpets.
Highest Setting - For plush pile carpet.
NOTE : For optimal cleaning performance, adjust to the lowest
practical setting. If your cleaner is difficult to push, adjust to the next higher setting.
Edge Cleaning Feature
The Edge Cleaning Feature helps the cleaner to clean edges of rugs and floors effectively, allowing suction to
reach against walls and near furniture.
Cleaning Tool Attachments
Attachment tools can be used to clean furniture, drapes, stairs, or in corners. Place the vacuum on the floor with
the handle in the upright position while using attachment tools. Do not place the vacuum on top of furniture or
steps as the brushroller may cause damage.
1
Unhook hose (with cleaning tools attached) from the rear of the vacuum
cleaner.
2
Place desired tool on end of narrow wand. Press firmly and twist to connect the
tool to the wand.
A. Dusting Brush:
Use for hardwood furniture, table tops, books, lamps.
B. Crevice tool:
Use in corners, on stairs, baseboards, and behind furniture.
A
B
7
