M a i n t e n a n c e
Check Rotating Floor Brush and Drive Belt
1
Unplug cleaner from electrical outlet.
2
Place handle in Low position and turn vaccum cleaner
over so bottom side is up.
3
Remove the eight screws as shown with a screwdriver.
4
Turn over the cleaner again, and lift the Cover-Brush off.
5
Remove the eight screws, and lift the Brush Cover off.
6
Grasp Rotating Floor Brush at both ends and lift.
7
Clean strings, hair and other debris from Rotating Floor
Brush, paying particular attention to brush ends.
8
Clean strings, hair and other debris from Motor Pulley
and Drive Belt areas.
9
Check Drive Belt carefully for wear, cuts or stressed
areas.
10
Check Air Passageway for obstructions. Remove debris
from this area.
Replace Drive Belt
1
Unplug cleaner from electrical outlet.
2
With Rotating Floor Brush removed from vaccum
cleaner(Step1-6 of Check Rotating Floor and Drive Belt)
grasp old Drive Belt and remove from Motor pully.
Discard old Drive Belt.
3
Place new Drive Belt over motor pulley and stretch other
end over rotating Floor Brush in the space between the
bristles.
4
Place ends of rotating Floor Brush down into slots on
sides as shown.
5
Turn rotating Floor Brush by hand several times in
direction of motor pulley, if properly installed, Drive Belt
will center itself.
6
Reposition Brush cover and eight screws. Tighten
screws securely. Snap end of Brush cover into place.
10