-
Confirm that the NAS IP address and the camera IP address are in the same format.
ex) The NAS & camera subnet mask initial value is 255.255.255.0.
If the IP address is 192.168.20.32 then the NAS IP address should be in the range of
192.168.20.1~192.168.20.255.
-
Check whether you tried to access as another user without formatting the default folder saved
or used.
-
Confirm that you used recommended NAS equipment.
4.
Once the setting is complete, change the setting of the NAS from <
off
> to <
on
>
and click the [
apply (
)
] button.
5.
Access the NAS to check the available capacity and the total capacity.
6.
If the capacity is insufficient, check the data and click the [
format
] button to format
the NAS on your own.
`
Due to network access errors, you might be unable to save the NAS temporarily.
`
The data traffic will increase when the camera is set to higher resolution, higher bit rate, and/or higher
framerate.
If there is too much data traffic, some frame may be skipped although it is stored in a full frame.
`
When a frame skip occurs, images are saved at the rate of min. one image per sec.
setup screen
92_
setup screen
