Samsung R408, User Manual

Page: 34 / 96

Intentional emitter per FCC Part 15
Low power, Radio LAN type devices (radio frequency
(RF) wireless communication devices), operating in the
2.4GHz/5GHz Band, may be present (embedded) in
your notebook system. This section is only applicable if
these devices are present. Refer to the system label to
verify the presence of wireless devices.
Wireless devices that may be in your system are only
qualified for use in the United States of America if an
FCC ID number is on the system label.
This device is restricted to indoor use due to its
operation in the 5.15 to 5.25 GHz frequency range.
FCC requires this product to be used indoors for the
frequency range 5.15 to 5.25 GHz to reduce the potential
for harmful interference to co-channel Mobile Satellite
systems. High power radars are allocated as primary
users of the 5.25 to 5.35 GHz and 5.65 to 5.85 GHz
bands. These radar stations can cause interference with
and /or damage this device.
The FCC has set a general guideline of 20 cm (8 inches)
separation between the device and the body, for use of
a wireless device near the body (this does not include
extremities). This device should be used more than 20
cm (8 inches) from the body when wireless devices are
on. The power output of the wireless device (or devices),
which may be embedded in your notebook, is well below
the RF exposure limits as set by the FCC.
This transmitter must not be collocated or operate in
conjunction with any other antenna or transmitter except
the installed Bluetooth transmitter.
Operation of this device is subject to the following
two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesired operation of the device.
Wireless devices are not user serviceable.
Do not modify them in any way.
Modification to a wireless device will void the
authorization to use it. Contact manufacturer
for service.
FCC Statement for Wireless LAN use:
“While installing and operating this
transmitter and antenna combination the
radio frequency exposure limit of 1mW/cm2
may be exceeded at distances close to the
antenna installed. Therefore, the user must
maintain a minimum distance of 20cm from
the antenna at all times. This device can not
be colocated with another transmitter and
transmitting antenna.”