OfficeServ 7400
INSTALLATION
TECHNICAL MANUAL
PART 7 MAY 2010
7.36
Figure 7.33 Connecting Common Bell
MISC 1 and MISC 2 ports are located on the front panel of the MP40.
WARNING
: Do not attempt to connect commercial AC power to these contacts.
1)
After connecting a common bell, you must assign it in MMC 601 to a group as a ring
destination by using the code for common bell.
2)
After wiring to the contact pair, set contacts for continuous or steady operation.
3)
Next, program hunt group to include the common bell.
4)
Assign the trunk to ring the hunt group containing the common bell. Common bell
control can be used with station hunt groups, individual stations and universal answer.
7.2.5 Ring Over Page
When a customer-provided paging system is installed, incoming calls can be assigned to ring
over page. Program the C.O. line or C.O. lines to ring a hunt group. Using MMC 601, assign the
DN number of the Page Output (voice) for the MIS board being used as a member of the
group or as the NEXT PORT for the overflow destination. Other stations may be assigned to
the same group to provide ringing to phones and the paging system at the same time.
MIS
FUNCTION # in MMC 724
DEFAULT
DN
CAB1
CAB2
CAB3
03 361
364
367
7.2.6 Connecting WEBMMC/OIT to the OfficeServ 7400
The WebMMC/OIT (OfficeServ Installation Tool) program is a web-based administrative tool
that allows you to locally or remotely program and configure the OfficeServ 7400 system.
Please refer to the WebMMC or OIT User manual for installation and user instructions.
Dry contact #1
(For common bell)
Dry contact #2
(Page Relay)
(For external broadcasting)
Dry contact #3
(Page Relay)
(For external broadcasting)
MISC 1
MISC 2
Home Page
Table of Contents
Home Page
Table of Contents
