Samsung OfficeServ 7030, Installation Manual

Page: 95 / 105

CHAPTER 7. Starting the System
7.1.2 Safety Conditions
The building where the OfficeServ 7030 system is installed should have lightning rods and
groundings to protect the system from lightning and electric leakage.

Check if the OfficeServ 7030 system is not inclined and is in level position.

Do not place devices that may cause electromagnetic interference near the system.

Place a fire extinguisher near the system. Since spring coolers can seriously damage
the system, use extinguishers such as Halor 1301 and Carbon Dioxide.

Ensure that the input power of the OfficeServ 7030 system is AC 200~240 V. Do not
share the power with other electric devices, such as motors and compressors.
 Check if the AC voltage switch of the PSU is properly set according to the voltage of
the input power. (200~240 VAC)

Check if the grounding terminal on the rear panel of the system is properly connected
to the external grounding.
7.2 Starting the System
To start the OfficeServ 7030 system, proceed as follows:
1) Check if the boards and cables are properly mounted and connected to the OfficeServ
7030 cabinet.
2) Turn on the power of the OfficeServ 7030 basic cabinet, and turn on the power of the
expansion cabinet.
3) Check the LEDs from the base boards mounted on the OfficeServ 7030 cabinet.

The RUN LED of the base board turns green and the MEM LED flashes when the
system starts the booting process normally.

Once the booting is completed, the RUN LED of the base board flashes green, and
the MEM LED stops flashing
4) The MEM LED of the base board flashes green when the Flash Memory is accessed.
2 © SAMSUNG Electronics Co., Ltd.