Samsung MWR-WW10N, Installation Manual

Page: 7 / 24

7 English
Wir
ed Remot
e C
ontr
oll
er
Installation
5 Reassemble the Wired Remote Controller.
NOTE
࡛ Align the controller with the upper groove first, and then insert it by
turning it downwards as shown in the figure.
After assembly, check and confirm that no wires are stuck in the gap
between the back and front covers.
6 Remove the front protective film.
CAUTION
࡛ Ǯ˵ʪ̈͝͝ϑϩɇ̷̷̈͝˝ɇǮ̈θʪʒŵʪ͔ͱϩʪAͱ͝ϩθͱ̷̷ʪθɵцЇϑ̈͝˝ɇʀɇɵ̷ʪ̷ͱ͝˝ʪθϩ˵ɇ͝ߣߢऌ͔࣑ߥߤ࢏ߪߢऌ˙ϩ࣒ࡥцͱЇ͔Їϑϩ̈͝ϑϩɇ̷̷ϩ˵ʪ
communication cable and the power cable separately. (Electrical interference can cause the Wired Remote
Controller to malfunction.)
࡛ When installing your Wired Remote Controller on the wall, consider the size of the wire hole, and select a wire
with a proper thickness.
࡛ Wire that is connectable to Wired Remote Controller PCB.
ࣞ If you install the Wired Remote Controller by reclaiming, install it according to U-terminal cable specification.
ࣞ Ã˙цͱЇ̈͝ϑϩɇ̷̷ϩ˵ʪǮ̈θʪʒŵʪ͔ͱϩʪAͱ͝ϩθͱ̷̷ʪθɵцЇϑ̈͝˝ϩиͱΧ̈ʪʀʪϑͱ˙ťǤAӥθʪࡥθʪ͔ͱЭʪϩ˵ʪߥߢऌʀ͔࣑ߣߤऌ̈͝ʀ˵࣒ͱ˙ϩ˵ʪ
sheath of the cable and install it only with the two pieces of wires. (Recommended specification: AWG20)