Samsung MWR-WW10N, Installation Manual

Page: 8 / 24

Wired Remote Controller Installation
8 English
Wired Remote Controller Installation
Wir
ed Remot
e C
ontr
oll
er
Installation
࡛ The following are the specs of the compression ring terminal connected to your Wired Remote Controller PCB.
Stud
W
t
E
F G
L
ØD
ŵɇ͝˝ʪͱ˙ťʪθ͔̈ϩϩʪʒǮ̈θʪϑ Rated Size Stud Size Basic Size [mm (inch)]
AWG
mm²
(inch²)
mm²
(inch²)
mm
(inch)
t ØD G E F W L
22~16
0.25~1.65
(0.0003 ~ 0.0025)
1.5
(0.0023)
3
(0.1181)
0.7
(0.0275)
3.8
(0.1496)
10.0
(0.3937)
4.5
(0.1771)
6.5
(0.2559)
6.0
(0.2362)
21.2
(0.8346)
࢜đɇӱ͔Ї͔ʒ̈ϑϩɇ͝ʀʪ˙ͱθʀͱ͝͝ʪʀϩ̈͝˝ʀͱ͔͔Ї̈͝ʀɇϩ̈ͱ͝ɇ͝ʒΧͱиʪθʀɇɵ̷ʪࡤߣߢߢऌ͔࣑ߥߤߪऌ˙ϩ࣒
࡛ Screws on the PCB terminal must be tightened with less than 6N-cm tightening torque. If the tightening torque is
greater, it may damage the screw thread.
Tracking Your Indoor Unit from the Wired Remote Controller [See the image
A
]
1 Tracking of your Wired Remote Controller will automatically start when you turn on the power after installation.
2 If you want to perform tracking again after installation, then press the and buttons at the same time for
more than 5 seconds.
࡛ The system will reset, and tracking will start again.
3 During tracking, the total number of currently searched indoor units will be displayed.
4 Ãϩ͔ɇцϩɇ̧ʪɇɵͱЇϩߧ͔̈͝Їϩʪϑɇϩ̈̈͝ϩ̈ɇ̷̈͝ϑϩɇ̷̷ɇϩ̈ͱ͝ͱθи˵ʪ͝цͱЇθʪࣛϑʪϩϩ˵ʪđɇϑϩʪθϑʪϩϩ̈͝˝࢏
NOTE
࡛ The operation displays on the remote controller may differ depending on the selected language.
࡛ If you want to perform tracking again after installation, then press the and buttons at the same time for
more than 5 seconds.