DCS-VIP User Guide
68
!
Primary Gateway : Enter the gateway, the IP address of the DCS-VIP .
NAT Setup
NAT (Network Address Translation) will enable more than two users to connect to
the network using a single user account. This function is valid only for ISP
connection. On this screen, set the following parameter values and click the Set
button.
NAT Table Configuration
!
Global IP Address : For the initial link to the ISP, set this IP address (10.0.0.1).
If the link succeeds, the ISP will automatically allocate an IP address, which will be
saved in this field as the NAT global IP address.
!
Subnet Mask : For the initial link to the ISP, use any subnet mask. When the ISP
allocates a NAT global IP address, the subnet mask value will automatically be set
up. In general, 255.255.255.0 is used as subnet mask.
!
NAT Entry Status
$
: To generate the NAT table defined on this screen, select
‘CREATE’, and if you want to delete it, select ‘DELETE'.
!
Network IP Address, Subnet Mask : Enter the DCS-VIP network address range
and subnet mask. You must enter the numbers as formatted in the following
example.
168.219.81.0,255.255.255.0;
NAT Global Configuration
!
NAT Port Translation
$
: To perform port conversion according to address
conversion of NAT Global IP address., select ‘YES’
!
NAT Feature : To use NAT function, select 'ENABLE'.
Group 2 (IPX Option
Group 2 (IPX Option
Group 2 (IPX Option
Group 2 (IPX Option)
)
)
)
You can set up the options for IPX, which is the network layer protocol for Novell
NetWare. Set the following parameter values and click the Set button.
IPX Setup
When you configure Ethernet using the DCS-VIP, you need to set the following
parameters if you want to use the devices connected to each other in the NetWare
network environment.
!
IPX Internal Network Number : IPX network number of Ethernet itself. MAC
address of system is mainly used. The network number of the IPX address is 32-bit
hex values separated with dots.
!
IPX Node Number : IPX node number of Ethernet itself. The node number of the
IPX address is 48bit hex values separated with dots.
!
IPX Global Administrative Status : To operate Ethernet IPX, select 'ENABLE'.
!
IPX Port Network Number (Hex Value) :
Enter the IPX number of network on
the side of Ethernet.
!
IPX Port Administrative Status : To operate Ethernet IPX number, select
'ENABLE'.
PPP Setup
For PPP connection in NetWare network environment PPP, set up the parameters
below.
Subnet mask
Network address
