37
English
Installation Pr
oc
edur
e
(*2) An FCU relay (MIM-F10N) must be installed in order to connect with the host controller and the wired remote
control. Set this option to '1' if an FCU is installed alone without connecting to a host controller.
Set this option to '1' if multiple FCUs (up to 16) are installed and connected to one wired remote control.
(*3) If the air conditioner is operated for more than 1 hour under the conditions that the heating fan is on and [(Eva in +
kЭɇͱЇϩ࣎ࢥߣࣅौߧߦঐࡡkߢߣߩͱʀʀЇθϑࢋ
(*4) E128 is skipped.
5
Check whether the option values that you have set are correct by pressing the Operation or Mode button repeatedly.
[SEG2, SEG3]
[SEG14, SEG15]
[SEG6, SEG8]
[SEG18, SEG20]
[SEG4, SEG5]
[SEG16, SEG17]
[SEG9, SEG10]
[SEG21, SEG22]
[SEG11, SEG12]
[SEG23, SEG24]
6
Save the option values into the fan coil unit:
• Point the remote control to the remote control sensor on the fan coil unit and then press the (Power) button on
the remote control twice.
Make sure that this command is received by the fan coil unit. When it is successfully received, you can hear a short
sound from the fan coil unit. If the command is not received, press the (Power) button again.
7
Check whether the fan coil unit operates in accordance with the option values you have set:
• Reset the fan coil unit by disconnecting and then reconnecting the power cable of the fan coil unit or by pressing
the RESET button on the outdoor unit.
• Remove the batteries from the remote control, insert them again, and then press the (Power) button on the
remote control.
Setting the fan coil unit address (main / RMC)
1
Make sure that the power is supplied to the fan coil
unit.
• If the fan coil unit is not plugged in, it must include
a power supply.
1(L)
F2
2(N)
F1
Fan coil unit
2
Make sure that the panel or display is connected to the fan coil unit so that it can receive options
3
Set an address (main or RMC address) for each fan coil unit using the remote control, according to your air
conditioning system plan.
4
The fan coil unit addresses (main and RMC addresses) are set to 0A0000-100000-200000-300000 by default.
Summary of Contents for AGTN1DKH Series
Page 41: ...41 English Appendix Memo ...
Page 42: ...42 Memo English Appendix ...
Page 43: ...43 English Appendix ...
Page 44: ...DB68 09309A 00 ...
