Studio GT
Owner’s Manual
12
INSTALLING THE STUDIO GT
Windows 7 & Windows Vista
The Studio GT does not require any special
drivers or software. Just plug in the Studio
GT into a USB port on your computer and
everything is installed automatically.
1.
The first time you plug the Studio GT
into a USB port, Windows 7 and Vista will
install the universal drivers for that port. A
balloon tip will pop up, telling you it has
found the USB Audio codec (Figure 1).
2.
When it is finished installing the drivers,
it will say “Your new hardware is installed
and ready to use” (Figure 2). This balloon
will not pop up again for the same USB
port.
3.
The Studio GT becomes the Default
Device after you plug it in and defaults
to maximum volume. Double-check this
by hovering over the speaker icon in the
bottom right hand corner of the screen.
It should show Volume:100 and "Samson
StudioGT".
4.
If it is not the default device, you can set
it under the Sound Properties panel in
Control Panel (figure 3).
5.
Select the “Recording” tab. Select the
“Samson StudioGT” from the list.
Figure 1
Figure 2
Installing the Studio GT is a simple procedure that takes just a few minutes. Since the
Studio GT is USB compliant, you can use most any PC, connect the included USB cable
and plug and play. You will be able to control your StudioDock using the standard
audio interface controls in the MAC or Windows operating system. You will find detailed
instructions on setting up Windows 7 & Vista in the following sections of this manual.
Figure 3