Samson Media 6, Original Instructions Manual

Page: 6 / 40

6 EB 9527-2 EN
Communication with Media 6 Differential Pressure and Flow Meter
To download configuration data from the software to the SAMSON memory pen or to up -
load data from the memory pen, a SAMSON modular adapter must be inserted into the seri -
al interface of the PC or laptop to connect the memory pen. See the Operating Instructions
u
EB 6661 for TROVIS-VIEW 4 software .
When the Media 6 device is not connected, the default settings are shown in
TROVIS -VIEW 4. A TROVIS-VIEW 4 file (*.tro) can be loaded and edited by selecting Open
in the File menu.
Note:
New records created in TROVIS-VIEW 4 firmware version 3.00 or higher are not
compatible with earlier versions (e.g. firmware version 2.30).
2 Communication with Media 6 Differential Pressure and Flow
Meter
To establish communication between the software and the Media 6 device, the electrical con -
nection of the Media 6 device must be performed as described in the Mounting and Operat -
ing Instructions
u
EB 9527-3.
To establish communication, the serial interface of the computer must be connected to the se -
rial interface port of the Media 6 device using the SAMSON connecting cable. Following
this, start TROVIS-VIEW 4 and perform the basic settings. The Media 6 device can be config
-
ured step-by-step using the start-up wizard.
Write protection switch on the Media 6 device set to OFF .
Refer to the Operating Instructions
u
EB 6661 on how to use the TROVIS-VIEW 4 software.
