SamplexPower EVO-30AB, Owner'S Manual

Page: 27 / 96

26 | SAMLEX AMERICA INC. SAMLEX AMERICA INC. | 27
5.3 EVO-RC-PLUS Remote Display Operation
The EVO-RC-PLUS Remote will display EVO-30AB settings and current status. It also
supports other EVO
TM devices connected on the bus such as the EVO TM Inverter/Charger.
The functions provided by the EVO-RC-PLUS when connected to the EVO-30AB are
described below.
For a full description of the EVO-RC-PLUS and operation with an EVO TM Inverter/
Charger, refer to the EVO-RC-PLUS manual. Installation of the remote can be found in
Section 1 of the EVO-RC-PLUS manual.
Fault
1
2
3
4
5 6 7 8
9
1. LCD Screen:
- 4 rows of 20 characters each
- Blue screen with white characters
2. ON/OFF Key
3. Blue LED “Status”
4. Red LED “Fault”
5. Navigation Key “Back”
6. Navigation Key “Up”
7. Navigation Key “Down”
8. Navigation Key “Enter”
9. SD Card Slot – FAT16/32
format, up to 32 GB
10.
RJ-45 Jack ( 8P8C )
11.
RJ-12 Jack ( 6P6C )
10 11
Figure 5.2 EVO-RC-PLUS Layout
5.3.1 Navigating the Remote
LCD Display (1) – This 4-line LCD display shows status and information for the EVO TM
devices. All Setup Menus and faults also appear on the LCD display.
The level of brightness / dimming of the LCD backlight can be programmed to suit
user preference.
On/Off Key (2) – This button has no function for the EVO-30AB. The On/Off Key is used
for powering ON and OFF the EVO
TM Inverter/Charger. See EVO-RC-PLUS manual for more
details.
Status LED (3) – Blue LED indicator for indicating operating status. This indicator will
blink every 5 seconds if the remote is connected to EVO-30AB only. Otherwise, it will
operate as shown in Section 6 of EVO-RC-PLUS manual.
SECTION 5 | CONSTRUCTION, LAYOUT & CONTROLS