2021_08_31-08:30
EN
6
816 809 R. 08/21
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
GREASE FILLING
GREASE FILLING FROM A BULK CONTAINER
GREASE PRIMING
OPERATION
SUCTION FILLING
FILLING WITH A PUMP
DISPLAY AND WORKING LIGHT
1. Unscrew the grease tube from the gun.
2. Insert the open end of the tube under the grease surface.
3. Slowly pull the pulling rod back while pressing the tube into the grease
surface of the container to prevent air from entering the tube.
4. When you have fully filled the tube and the rod is fully extended, lock
the rod with the locking tab. The tube supplied may vary depending
on the model of gun. If the tube does not have a locking tab then
extend the rod until a groove is visible and move the rod sideways to
lock it.
5. Screw the tube into the grease gun and tighten it firmly.
6. Release the rod and insert it into the grease tube.
7. Slightly unscrew the gun tube until some grease comes out of the end
of the tube to eliminate possible air pockets. Tighten the
tube immediately.
8. Use the bleed valve to release any trapped air. See “Grease gun priming”.
9. Clean the gun of any excess grease.
10. Reset the display meter.
1. Insert the rod completely into the tube.
2. Fasten the filling coupler on the gun filling valve (3).
3. Slowly start the filling pump and watch the rod move.
4. When the filling rod is fully extended, approximately 20 cm (8 inch),
stop the pump immediately. Never overfill!
1. Make sure the rod is not locked.
2. Insert the rod into the tube.
3. Loosen the screw on the bleed valve without removing it completely.
4. Pull the trigger for 10-20 seconds.
5. If no grease comes out of the hose end, repeat from step 3.
Pressing the gun trigger automatically activates the display and the
working LED light. To save energy, both are automatically switched off
after 20 seconds.
The LED light can be turned on and off independently by pressing
button “A” (16).
WARNING:
The gun can be equipped with a low pressure filling
valve (3). Never mount a high pressure lubrication fitting, serious
damage can occur due to high pressure. Use only low pressure
couplings.
WARNING:
Air pockets trapped in the grease can cause a lack or
loss of priming in the gun. Always remove air after refilling the
grease tube or when the gun loses priming and does not pump
grease.
!
!
5. Disconnect the charging coupler.
6. Use the bleed valve to release any trapped air. See “Grease gun priming”.
7. Set the display meter to zero.
The display shows the grease level in the cartridge, the amount of grease
dispensed, the mode of operation, the units of measurement and the
battery charge level.
