Sammic SL-1100B, User Manual

Page: 9 / 32

M
ACHINE
D
RAINING
Models with no drain pump : Remove the
top filters from the tub and take out the
overflow pipe. Water will fall by gravity.
Models 'B' with a drain pump :
·Open the lid and take out the drain plug.
·Press the drain key (A-7) as specified on
the control panel, with the lid open. The
drain pump operates during the program-
med time at the end of which it stops
automatically. By pressing the key, you
can successively start and stop the pump.
·Put the overflow drain plug and filters in
place again.
·Turn the main switch off and close the lid.
Models 'BP'
Draining of the Air gap-Break tank: In case
of extended non-utilization of the machine,
the tank should be emptied. To do so :
1.Drain the wash tank
2.Close the water inlet.
3.Close the hood: water will flow into the
wash tank by means of the pressure pump.
4.Drain the wash tank.
When boiler draining is done by the techni-
cal assistance service, the water break-tank
is emptied through the boiler.
TANK CLEANING
The tank should be cleaned after every
washing process, at the end of the day,
proceeding as follows: Fig.C
· Open the hood and take out the overflow
pipe.
· Open the hood, remove the top filters
from the tub and clean them carefully.
(Never remove the filter from the powe-
red pump (5) when the tub is dirty.)
· Drain water out of the tub.
· Once the tub is totally empty, remove the
filter from the powered pump (5) and
clean it.
·On models 'B' with a drain pump, also
remove the screwed-on filter of the drain
pump (3) to clean it. As shown on Figure
C, give the filter (3) a quarter of a turn to
unscrew it. After cleaning, screw the filter
on again.
·To clean the interior of the wash tank,
close the lid and start the machine (after
having previously removed the drain
plug). In this way, water will enter via the
rinsing dispersers and the machine will
clean itself. This operation should be
carried out for 2 to 3 minutes.
·Finally, clean the bottom, walls and inte-
rior of the tank.
·Spray arms must be cleaned periodically.
If rinsing is deficient, the cause may be an
obstruction of the jets. In this event, dis-
mount the arms and clean the jets.
·The outside of the machine MUST NOT BE
washed under a direct water jet; instead
you can use a wet cloth and any ordinary
detergent.
·DO NOT USE any abrasive detergent
(etchant, concentrated lye, etc.) nor any
scourer or scraper containing normal
steel that will cause rust to develop on the
machine.
OTHER IMPORTANT REMARKS
·Before cleaning, servicing or repairing the
machine, it is necessary to unplug it from
the mains.
·When the appliance is going to be inacti-
ve for a long period of time or at night, the
lid should be kept open for aeration and
avoiding nasty smell.
·In case of a drain pump failure:
1.Drain the wash tank into a container until
the water level drops below the drain plug.
2.With the drain plug in place, remove the
front bottom panel and change the pump
(this can be done without moving the
machine). In order to drain the dishwasher
manually, connect a drain hose to the
collector. On pulling out the drain plug,
water flows out of the tank by gravity.
·In the event the power supply cable
should get damaged and have to be repla-
ced, the repair may only be done by a SAM-
MIC approved assistance service.
·Airborne noise: the emission noise level
measured on a typical machine is 71 dB(A)
at a distance of 1m.
9
ENGLISH